Support for fixing on gate poles for starting gate HL7-1 and HL7-3

This Modem Kit will allow you to control wireless your panel (RS232 or RS485) over a distance of up to 20 km. Operating on 863-870 MHz, these modem is certified and can be used without license. Certified, the modems comply with the 2010 edition of the European Directive RTTE EN300-220.

Our latest HL3-5 photocell has an internal quartz clock, and an integrated 500mW radio module. Kit includes 1 wireless photocell with integrated 500 mW radio transmitter, 1 reflector, 1 antenna, 1 charger and 1 suitcase. 500mW Radio Receiver for receiving cell pulses sold separately. RECEIVER HL675-RX   

This power supply is compatible with CP520, CP540, CP545, HL440, HL610, HL615, HL670 and HL675.

Three swimming-specific modes offer the possibility to record and analyse number of strokes, differential times, average strokes as well as comparing the times of 2 swimmers at the same time and even timing of up to 9 swimmers with a mass start method. Discover our presentation video below.

This power supply cable is compatible with CP520, CP540, CP545, HL440, HL610, HL615, HL670 and HL675.

No more room for doubt on a tight finish with the Video-Finish-Pro camera from Vola.Combining simplicity of use, sharpness and precision, the Video-Finish-Pro 2D system will surprise you.The pack includes :   The Video-Finish-Pro 2D camera equipped with an f:16mm lens and its protective case A coded dongle with the license to use the Video-Finish-Pro software A 10m fiber link A Wifi access point DOWNLOAD (version 4.0.20)

Complete individual kit including :     Cobra 200 Batt transponder (ITSCOBRAT200B)     Individual charger (ITSCOBRATB-CHI) with USB power supply (AC adapter not included)     Holder (ITSCOBRATB-S)     Clip (ITSCOBRATB-A) The Cobra 200 transponder is recommended for fast vehicles (autocross, motocross, trucks...).Official timing system for all French FFSA and UFOLEP circuit championships (dirt and ice).This transponder is recharged with a specific charger and fixed with a support and clip.

Foams for mounting TAG RFID serve to isolate the RFID chip from the holder that can interfere with the proper operation of the system. The use of these foams is compulsory whatever the type of use.